A fuse protects the (expensive) circuit for too high currents. When the current becomes too high the (cheap) fuse melts and the current is stopped, preferably before damage has been done to the circuit.
If the vswr (Voltage Standing Wave Ration) is high than call drop chance increase.
Diodes, like many other electronic/electrical components, will melt if the temperature is high enough. This would occur if the power dissipation were too high because the current was too high.
If the load current is too high, the power lost in the transformer windings will be too high and it will overheat. If the voltage is excessive, the power lost in eddy currents in the magnetic core will be too high and it will overheat.
Current transformers are used to measure electric currents. When current in a circuit is too high to directly apply to measuring instruments, a current transformer produces a reduced current accurately proportional to the current in the circuit, which can be conveniently connected to measuring and recording instruments.
the current becomes too high
the ratio of magnesium to oxygen is .29 : .18
The mole ratio of the sample will be too high. This is because the amount of CO2 will be lower than if the reaction went all the way and produced the proper amount of CO2.
It melts (fuses).
if you mean fuzzy as in not a very high resolution its because you have too high of a pixel ratio for cable (meaning if you have 1080p or anywhere near that ratio then it is too much for cable), i would advise upgrading to charter high definition though if you mean that its static i cannot explain that sorry.
A fuse protects the (expensive) circuit for too high currents. When the current becomes too high the (cheap) fuse melts and the current is stopped, preferably before damage has been done to the circuit.