answersLogoWhite

0


Best Answer

Very high

User Avatar

Jonathan Bethea

Lvl 2
4w ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What kind of head pressure would you see if the condenser fan became inoperative?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Physics

After heat is absorbed into a condenser medium in a water cooled condenser the heat can be deposited in one of two places what are they?

There is only one condenser. That would be an air condenser.


What would happen to the air pressure when the air is sucked out?

The air pressure would reduce.


Why would your air conditioner have normal head pressure and a low suction pressure?

There is no such thing as normal head pressure. It is all based on temperature and calculations. Need to know indoor air temp, outdoor air temp, wet bulb versus dry bulb. Need to know specifics. so when outside ambient temp is 90 and I'm running 255 head with a clean condenser. that isn't normail head pressure? that's pretty normal to me. working with r22 the correct answer would be. If you are sure your head pressure is where it should be, with correct freon type. low suction pressure can be caused by no blower motor, closed or blocked registers, clogged filter or evaporator, lack of airflow, undersized evaperator or oversized AC, restricted metering device(TXV, piston) blocked returns. but he is right you need a lot more info what's your superheat/subcooling? what's your delta T, is you head pressure really wre it should be? what's changed since this started happening. How low issuction pressure what's your evap saturation temp? is coil freezin up? what are your pressures exactly is condenser temp 30 degrees warmer than outside temp. with r22. do you know what you are doing????


Discuss the possible variations that would affect pressure if hot fluid is used in a pressure calibrator?

Discuss the possible variations that would affect pressure if hot fluid is used in a pressure calibrator?"


Which type of current does a windmill produce?

Direct current as would a magneto. For this reason it can be used with an integrated battery-condenser plant which would keep things going during slack periods.

Related questions

What kind of head pressure would you experience if the condenser motor became inoperative?

The compressor would continue to operate until the high pressure safety switch shut it down, if the switch failed the pressure relief device would blow and you would lose all of the refrigerant. As far as how high would the pressure get, the settings on the two devices depend on what type of refrigerant is used and you do not mention that.


What kind of head pressure would you experience if the condenser fan motor became inoperative?

The compressor would continue to operate until the high pressure safety switch shut it down, if the switch failed the pressure relief device would blow and you would lose all of the refrigerant. As far as how high would the pressure get, the settings on the two devices depend on what type of refrigerant is used and you do not mention that.


What symptoms would be indicative of an oil logged condenser?

High discharge pressure and low liquid line pressure


A clogged air conditioner condenser would cause what?

high head pressure and a higher supply temp.


Why would the dipstick on a lwb transit 1997 pushed out from pressure building up underneath?

Engine oil dipstick? Could be the PCV system is inoperative or the engine has excessive blow-by.


Why would your car's condenser ice over on the outside?

It has an internal blockage! Air conditioning gas cools as it expands (as it changes from liquid to a gas). It is meant to be a liquid in your condenser but if your condenser has a blockage (say some dirt or other contaminent) then the liquid loses pressure on the other side of the blockage and becomes a gas. This makes your condenser really cold and frosty on the outside!